FIXED PANIC BUTTON
The PB1B/PB2B panic buttons are designed to provide a discrete, repeating alert to receiving devices which can be pagers and/or fixed receivers
Latching With Reset By A Key Switch
Designed for wall or under-desk mounting, the PB1B and PB2B send a repeating signal when activated until it is reset with a key.
PB1B has a single front mounted button, PB2B has a button each side which should be pressed simultaneously to activate.
Multiple units can be used on a site, each sending its own unique identifier to the receiving devices, which could be pagers, fixed receivers or a combination of both. UHF SRD radio transmitter with a range of up to approximately 200 metres (dependant on site conditions) Power is provided by a standard 9V battery.
Tx Frequency Range
9V alkaline battery
Transmit <80mA @ 25mw
Sleep Mode <80uA
430MHz - 470MHz
(W) 60 x (L) 80 x (D) 43 mm (excluding tabs)
See data sheet for full specification
Scope’s policy is one of continuous development and specifications are subject to change without prior notice