DIGILINK 3

Scope DL5 / DL10 DigiLink Transmitters Have Programmable UHF 5 Or 10 Switching Inputs For Telemetry Applications

Volt-Free or Voltage Triggers

Scope DigiLink transmitters have either 5 or 10 programmable zone inputs.

Each zone when triggered, will automatically send the active zone message to  pagers. Use with the  RX10 Receiver and  suitable aerials to provide a telemetry link between panels or other devices.

Regular ‘In Service’ calls can be automatically sent to the receiver which can trigger a ‘fault’ zone if the calls are not received. This gives the end-user confidence that the system is operating properly. The 10 zone version also has a special ‘Burglar Alarm’ mode with configurable entry/exit delay, transit zones and entry zone.

For advanced users who wish to program the unit themselves, a Programming Kit can be purchased. This consists of Windows based application software and a USB cable for PC. This allows all functions to be programmed and stored in secure non-volatile memory.

12VDC, 24VDC and mains powered versions are available, with an optional battery back-up facility for the mains version

Key Features

• 5 and 10 zone models, fully programmable activation (N/O, N/C or Change of State). Hardware configurable as either voltage or ‘dry’ switched inputs
• Each zone and each zone state is fully programmable
• Adjustable trigger times, delays, alarm repeats are all programmable options plus a new ‘Burglar Alarm’ mode on the 10 zone version
• UHF POCSAG signalling format ensures excellent propagation even in difficult environments
• 12VDC, 24VDC and mains powered versions available

Power Input

Footprint

90 – 230V AC 50-60Hz @ 800mA

(H)* 328 x (W) 190 x (D) 75 mm
[ * 496 mm with 14BNC antenna]

Mains Powered Models​

Power Input

Footprint

12V Model: 12V – 13.8V DC @ 0.8A (max)
24V Model: 13.8V – 24V DC @ 0.8A (max)

(H)* 185 x (W) 140 x (D) 42 mm
[* 335 mm with 14BNC antenna]

DC Powered Models​

Frequency Range (MHz)

RF Output

458.5125 – 458.9375

500mW

All Models​

See data sheet for full specification

Scope’s policy is one of continuous development and specifications are subject to change without prior notice​

Specifications​

Programming Features

• Individual Zone States (normally open, normally closed or change of state)
• Voltage Input Triggers (5-18V)
• Input trigger time
• Transmission Delay
• Transmission repeat functions
• Local output (open collector)
• Identity code (capcode) for each zone and each state.
• Preformed text messages, either numeric or alphanumeric.
• Low Battery Signal
• ’In Service’ call period
• ’Burglar Alarm’ mode (10 zone version only)
• Tamper zone

Ports

UK Licence Requirement

5 or 10 dry contact/voltage inputs (configurable)
Open collector (siren) output: 1A max
Relay output for Power Fail indication
USB port for programming function only

None – Licence exempt.

General​